What would power two 10 inch subwoofers?

1. How many watts do I need for 2 subwoofers?
2. Will a 1000 watt amp push 2 10s?
3. How many watts does a 10 inch sub need?
4. What wattage subwoofer should I get?
5. Is a 1000 watt subwoofer loud?
6. What size amp do I need for 2 12 subs?
7. What if my amp is too powerful for my sub?
8. Is 200 watts enough for bass?
9. Is a 10 inch subwoofer enough?
10. What sounds better 10s or 12s?
11. Can I use two different size subwoofers?
12. Do two subwoofers make a difference?

How many watts do I need for 2 subwoofers?

Two subs on a 500 watts RMS amp will want about 250 watts RMS each. So you'll look for subs each rated for 250 watts RMS or more.

Will a 1000 watt amp push 2 10s?

Yes, its actually more than enough, the c104 is only 300 watt peak and 150 rms ... so between the 2 your only needing 300 watts to sufficiently power both. A 1,000 watt would work just fine. ... Oh and P.S. go with a 1,000 watt 2 channel lanzar amp... then bridge your speakers.

How many watts does a 10 inch sub need?

The Comp 10-Inch Subwoofer works best with a sealed or ported enclosure and 150 watts of recommended power. See below for more details.

What wattage subwoofer should I get?

If you have: A factory radio — you won't need more than 50 to 200 watts RMS of power for the bass. An aftermarket receiver — you might want 200 to 300 watts RMS of power. Amplified speakers with around 50 watts RMS per channel — 250 to 500 watts RMS is a good starting point.

Is a 1000 watt subwoofer loud?

A 1,000-watt subwoofer doesn't have to play any louder than a 100-watt subwoofer. The watt rating is a rough guide to how loud a subwoofer might be able to play, but it doesn't have to be louder. You always control the volume. In fact, a 1,000-watt sub may sound better at "regular" room volumes than a 100-watt sub.

What size amp do I need for 2 12 subs?

Then determine the amount of power your subwoofers can handle. RMS power handling of a 55 series 12” dual 2 ohm voice coil subwoofer is 400 watts. Two of these subwoofers would mean you need 800 watts of power at to the total circuit impedance.

What if my amp is too powerful for my sub?

Amplifiers can be too powerful for speakers. Speakers are limited by the electrical energy that they can convert into audio. As a general rule, if the amplifier produces more electrical energy than the speakers can handle, it may cause distortion or clipping, but damage is unlikely.

Is 200 watts enough for bass?

For home use, go with a bass amp in the 150-200 watt range. They have the power and headroom to sound good and have more and better features than smaller bass amps. As a bonus, these amps also have the power for playing in a low-volume group if the opportunity presents itself.

Is a 10 inch subwoofer enough?

Most 10 inch subwoofers will give you the ability to rattle the trunk, but if you don't like that, you don't have to turn the bass up. A 10-inch subwoofer in a sealed box is perfect for crisp, tight, punchy bass that makes sure you get the right amount of bass for your listening style.

What sounds better 10s or 12s?

When designing or upgrading a vehicular audio system, subwoofer size often dictates loudness. That means two 12s will sound louder than two 10s. If your music doesn't need a deeper bass or fast attack, you'll receive more sound consistency by going with the smaller subs.

Can I use two different size subwoofers?

Technically, yes you can install two different sized subs in the same box. For example, let's say you are making your own box and already have a 15” subwoofer and a 12” subwoofer.

Do two subwoofers make a difference?

Dual subwoofers will greatly increase the available system headroom, providing greater dynamic range, reduced output compression, lower distortion, and less potential for overdrive artifacts. In short, running duals will give you cleaner, more accurate bass at extreme drive levels.